Free roadside guide

How to Jump Start a Car

To jump start a car, connect red to the dead battery's +, red to the good battery's +, black to the good battery's -, and the last black clamp to bare metal on the dead car. Run the good car for a few minutes, start the dead one, then remove the cables in reverse order.

Step-by-step walkthrough

Dead car+-Bare engine metal (ground)Working car+-

Get ready · Step 1 of 13

Park safely and switch everything off

Put both cars in Park (or neutral with the parking brake on), turn both ignitions off, and switch off lights, heater and radio. Park close but do not let the cars touch.

Car won't start after a jump? Troubleshooter

Pick what you hear and see when you turn the key or press start.

Symptom

Most likely

The battery is still too low, or a clamp is not biting into clean metal.

What to try

  • Wiggle each clamp so its teeth cut through corrosion onto bare metal.
  • Let the working car run 5 more minutes, then try again.
  • If it still only clicks, the battery may not hold a charge. Have it tested or replaced.

Glovebox card: jumper cable order

Connect

  1. Red to dead battery +
  2. Red to good battery +
  3. Black to good battery -
  4. Black to bare metal on the dead car, away from the battery

Start, then disconnect in reverse

  1. Run the good car 2 to 5 minutes, then start the dead car
  2. Remove: black ground, black -, red good +, red dead +
  3. Drive 20 to 30 minutes, then get the battery tested
  4. Never jump a cracked, leaking or frozen battery

Hybrids and EVs

Most hybrids and EVs have a small 12-volt battery that can be jumped, usually from jump posts under the hood or in the fuse box. Many must not be used to jump another car. Check the owner's manual first.

Battery in the trunk or under a seat

Many cars with a hidden battery have a remote positive jump post and a ground stud under the hood. Use those instead of digging out the battery.

Push-button start and manual cars

With push-button start, hold the brake (or clutch) and press start as usual. Push-starting an automatic does not work, and push-starting a manual is a last resort that can damage a catalytic converter.

Jump starting FAQ

What order do you connect jumper cables?

Red to the dead battery's positive (+) terminal, red to the good battery's positive terminal, black to the good battery's negative (-) terminal, then the last black clamp to unpainted metal on the dead car's engine, away from the battery.

What order do you remove jumper cables?

Remove them in the reverse order: the black clamp from the dead car's ground first, then black from the good battery, red from the good battery, and red from the revived battery last.

Why connect the last black clamp to metal instead of the negative terminal?

The final connection can make a small spark. Making it on bare engine metal away from the battery keeps that spark away from hydrogen gas a weak battery can release.

How long should you leave the cars connected?

Let the working car run for 2 to 5 minutes before you try to start the dead car. Once it starts, remove the cables and drive for at least 20 to 30 minutes so the alternator can recharge the battery.

Why won't my car start after a jump?

Rapid clicking usually means the battery is still too low or a clamp has poor contact. A single click points to the starter. Cranking without starting points to fuel, spark or the key. Dying after the cables come off points to the alternator.

Can you jump start a hybrid or electric car?

Many hybrids and EVs have a 12-volt battery that can be jumped from the under-hood jump terminals, but some must not be used to jump another car. Follow the owner's manual for your model.

Stuck on the school run?

RideVillage lets another family in your carpool cover your turn with one swap request, so the kids still get picked up.

Explore RideVillage